Grass Valley Kayak HD Installation v.6.8.8 - Manual (Page 152)

152 Kayak HD — Installation and Service Manual
Section 4 — Maintenance
2. Press Rescan in the Device Control menu of the panel. The frame should
now be visible.
3. If the frame is still not visible, reboot both the frame and the panel.
Note In order to integrate Kayak HD devices into an existing network, ask the local
network administrator for the subnet mask of the network. Before changing
IP addresses always set the subnet masks of all Kayak HD devices to the
mask of the local network. If all changes are made and a frame is not visible
to the panel, press Rescan in the control panel Device Control menu.
Network configuration defaults:
Running Panel Tests
A series of test procedures are available to check the function of the Kayak
HD Control Panels.
To run the Control Panel tests, simultaneously press the buttons:
BlackPreset + Trans Preview + BGD (or Key 1... Key 4)
in the TRANSITION control panel.
IP address frame (DD/SD/HD): 192.168.0.70
Subnet Mask frame: 255.255.255.0
IP address Ram Recorder (SD/HD): 192.168.0.71
Subnet Mask Ram Recorder: 255.255.255.0
IP address panel (1, 2, and 3 M/E): 192.168.0.73
Subnet Mask panel: 255.255.255.0