Grass Valley Kayak HD Installation v.6.8.8 - Manual (Page 34)

34 Kayak HD — Installation and Service Manual
Section 2 — Installation
Safety Requirements
To prevent injury or equipment damage, read, understand, and follow all
installation safety precautions.
CAUTION The Video Processor frame weighs approximately 8.3 kg (18.3 lb). Provide
appropriate equipment to support the frame during installation.
WARNING Electrical potential is still applied to some internal components even when
power to the frame is off. To prevent electrical shock when working on this
equipment, disconnect the AC line cords from the AC source before
working on any internal components. Residual voltage may be present
immediately after unplugging the system; wait thirty seconds to allow
capacitors to discharge before working on the system.
CAUTION To avoid static damage to sensitive electronic devices, protect the Kayak HD
system from static discharge. Avoid handling frame modules in a high static
environment. Use a grounding strap when handling modules, and touch the
frame before you remove any modules.
WARNING Operate only with covers and enclosure panels in place — Do not operate
this product when covers or enclosure panels are removed.
Installation Tasks
After completing the Pre-Installation procedures, the recommended instal-
lation tasks given in this section are:
1. Unpack the equipment.
2. Install the Kayak HD Video Processor frame.
3. Install the Kayak HD control panel(s).
4. Connect all cables between Kayak HD devices.
5. Connect cables to video inputs and outputs.
6. Connect the power cables.
Power up and configuration, including setting IP addresses, is covered in
detail in the following sections of this manual.