Assigning on-air tallies – Grass Valley Kayak HD Installation v.6.8.8 User Manual
Page 104
104
Kayak HD — Installation and Service Manual
Section 3 — Configuration
Figure 64. Install – AUX Menu
Grass Valley recommends that you use upper AUX busses for monitoring
purposes. This leaves lower AUX busses free for special purposes, i.e.
external DPMs.
Note
If an AUX bus has been assigned a permanent internal source selection the
main control panel for that AUX bus is locked out.
1.
From the
Home
menu press
Install
- EBox - AUX
.
2.
From the menu displayed select an AUX bus.
3.
Press the
Modify
button in the bottom right of the
Install - EBox - AUX
menu
to display a list of sources that can be assigned.
4.
Select the source you want to assign and then press the
OK
button.
Note
See
for descriptions of the available sources.
Assigning On-Air Tallies
1.
From the
Home
menu press the
Config - EBox - Tally In
button.
2.
From the menu displayed select the AUX bus you want to assign On-
air Tally status.
3.
Press the
Tally Overall
button in the upper left of this menu.
8448_56_
r1