Gpi output 1, Gpi output 12, Adding a remote host – Grass Valley K2 Media Client User Manual Oct.10 2006 User Manual
Page 194: Host name, Controller id, Adding a remote host” on, Chapter 10 modifying configurations
194
K2 Media Client User Manual
August 15, 2006
Chapter 10 Modifying Configurations
NOTE: If you want to play a list that was created on another play channel, you must
ensure that GPI triggers assigned to the play channels use the same names;
otherwise the GPI triggers will not occur. Using identical GPI naming also allows
copying and pasting sections and events between lists.
Adding a remote host
GPI Output 1
.
.
.
GPI Output 12
Channel
R1, R2, P1, P2,
P3 (HD)
or
C1, C2, C3, C4
(SD)
Select the channel to trigger the
GPI output.
GPI Output 1
.
.
.
GPI Output 12
Trigger
Name
GPI-Out-X
Enter the name of the action
triggered by the GPI output.
GPI Output 1
.
.
.
GPI Output 12
Active
HIgh
Low
Select the active signal (high or
low) required. This is determined
by the external equipment
connected to the GPI output.
Under System|
Configuration,
select the Remote
tab…
And make settings as needed…
Host name
Enter the name or the IP address of the K2 Media Client where you want to
import or export streaming media assets. (Grass Valley recommends that you
use host names. For more information on host files, see the K2 Media Client
System Guide.)
Controller Id
Select a Controller id when adding a remote host that uses AMP remote
control protocol.
Under System|
Configuration,
select the GPI
tab…
And make settings as needed…