Grass Valley K2 Media Client User Manual Oct.10 2006 - Manual (Page 189)

August 15, 2006 K2 Media Client User Manual 189
Play channel video setup: HD/SD K2 Media Client
Play channel video setup: HD/SD K2 Media Client
Under System|
Configuration,
select the Channel
tab...
And make settings as needed…
Video Output Type
For information on
HD/SD up and down
conversions, see the
K2 Media Client
System Guide.
NTSC This choice available when Video
Reference is 59.94Hz (NTSC).
PAL This choice available when Video
Reference is 50Hz (PAL)
1080i (1920x1080i)
720p
Aspect ratio
conversion Bar
Crop
Half Bar
Stretch
Refer to “About video scaling
settings” on page 181 .
Still-play mode
Still-Play mode
settings determine
how to generate the
still-play signal for
the play channel
when it is setup to
freeze on last frame
of video in stop
mode. You can
select line
interpolated, or
interlaced.
Field (LIne-interpolated) This is the default setting and uses
the content of one field for both
fields during still-play for a one field
freeze. This mode eliminates the
motion jitter that can be present in
Interlaced mode. (This is the only
setting available for the 720p
format.)
Frame (Interlaced) This mode displays two fields in still
play mode for a two field freeze.
With this mode you might see some
motion jitter in still-play.
Test Mode
(Colorbars + Tone) On
Off
Temporarily displays 75% colorbar
signal on the channel output. It also
generates an audio tone on all audio
outputs. This setting is for test
purposes only, so it is not saved.