RLE LD2100 V.2.6 - Manual (Page 40)

40 LD2100 User Guide 800.518.1519
3 Web Interface
Delete an Image
If you uploaded a map or other image that you decide not to use, and you aren’t planning on
replacing it with another image, delete the image by going to Configuration>System/Flash
Management and click the button for the index location that contains the image (Image index 1
or 2).
Figure 3.11 Delete an Image
Mark Reference Points on the Map
Now that you have uploaded the map, it’s time to mark reference points on the map that you
can refer to if a leak occurs. These reference points are the overlay mentioned earlier - the
LD2100 places this data over the top of your image, to pinpoint alarms in real-time.
Since the LD2100 never actually edits your map, if you should need to update your map
image, previously designated map points will not need to be reconfigured. As long as you do
not change size of your map, previously mapped coordinates should not need to be adjusted
when you upload a new version of your map.
To mark reference points:
1 In the user interface, go to Configuration>Web/Map Settings.
The Web Configuration page displays.
Figure 3.12 Web Configuration Page—Map Alarm Coordinates (Graphical) Link