RLE LD2100 V.2.6 - Manual (Page 34)

34 LD2100 User Guide 800.518.1519
3 Web Interface
3.3.3 Virtual Zone Settings
Once you’ve designated how many virtual zones you’d like to have, you need to provide the
necessary information to define where the virtual zones are in your installation. Do this on the
Virtual Zone Settings page.
Figure 3.6 Virtual Zone Settings Configuration Page
3.3.4 Physical Zone Settings
Physical zones represent actual pieces of hardware that are connected to the LD2100. You’ll
use the Physical Zone Settings page to designate specific information about these physical
zones, but first you’ll need to designate the LD2100 as a Modbus Master and connect slave
devices to the LD2100. For complete physical zone configuration information, refer to
Chapter 4 .
Option Description
Zone # A fixed number, 1 - 32, used to designate the Zone.
Label Type a descriptive label for the zone, 30 characters or less.
End Distance Record the sensing cable’s distance measurement at the END of
the zone.
Zone 1 starts at 0 feet / meters, and you designate the end point for
Zone 1. Zone 2 starts at zone 1’s ending distance; you designate
where Zone 2 ends. Each subsequent zone begins where the
previous zone ends.
Table 3.4 Virtual Zone Configuration Options