One–button marking, List navigation – NewTek 3Play 4800 User Manual
Page 63
Page | 47
4.5.2 ONE–BUTTON MARKING
23. Finish marking any incomplete event, if necessary, by pressing OUT.
24. Wait for a few more seconds to elapse, and then press OUT only – without pressing IN
first.
25. Repeat this step several times, allowing a few moments to pass between repetitions.
Notice that – even though you haven’t pressed IN first – new ‘complete’ events have been added
to the CLIP LIST. As expected, the duration for each of these new events is four seconds. The
Out Point was set when you pressed OUT, and a suitable In Point is assigned as required.
4.6 LIST NAVIGATION
26. Press the | (Previous) button on the Control Surface.
Nothing happens. This is because you are still in LIVE mode.
27. Press the CLIP LIST Source Delegate button. A bright border is added to the CLIP LIST
module, and the background of the Channel Info pane under the (B) monitor changes
from green (representing LIVE) to blue (CLIP LIST).
28. Now that the CLIP LIST is delegated to Channel B, press the | (Previous) button again.
You’ll see that the view on the current output updates to show the prior event (the row
above in the CLIP LIST), and the blue highlight in the CLIP LIST moves to the Memo
column of a clip in that event row.
29. Press | (Next) to return to the original event.
30. Let’s try something slightly different. Find (or create, using IN/OUT) a clip that is at least
15 seconds long. Keep an eye on the output monitor as you perform the next steps.
31. Press (PLAY) to initiate playback, wait just one second– then press | (Previous).