NewTek 3Play 4800 - Manual (Page 52)

Page | 36
For SD sessions, Component or Composite
+ Y/C Analog Output Type alternatives are
available. For HD sessions the menu is
locked, since Component is the only valid
analog connection option.
Selecting the Composite + Y/C option
sends composite video output to the
second
BNC connector in the
corresponding output row (labeled Y), and
Y/C to the third and fourth connectors, labeled Pb and Pr,
respectively.
3.7.2 DISPLAY PORTS
The Display ports described back in Section 3.5.4 are also configured in the Output A and B tabs
in the Output Configuration dialog. The menu in the Extra Display control group allows you to set
the resolution sent to connected monitors.
3.7.3 AUX (3PLAY 4800)
3Play 4800 has an additional tab in the Output Configuration panel. The Aux pane provides
control over the third primary video output section on 3Play’s rear panel, referred to as the Aux
output. The video stream it displays is determined by the Channel Delegate active on the Control
Surface at the moment. Video from the delegated channel is also sent to Aux.
In the Aux control tab you will find a menu offering the same analog connection type options
discussed back in Section 3.7.1.
3.7.4 MULTIVIEW
Multiview options and layouts are found in the Workspaces menu (located in the Dashboard).
For best results, configure the Multiview Output to the native resolution of the external display
(monitor or projector) connected to it. See Section 6.4.2 for details of the Workspaces menu.
Figure 27