Pierce a workpiece, Pierce a workpiece -5, Powermax – Hypertherm Powermax105 Service Manual User Manual
Page 69
Hand Cutting
powermax
105 Service Manual
5-5
Pierce a workpiece
WARNINg:
SPARKS AND HOT METAL CAN INJURE EYES AND BURN SKIN. When firing the torch
at an angle, sparks and hot metal will spray out from the nozzle. Point the torch away
from yourself and others.
1. With the work clamp attached to the workpiece, hold the torch
at an approximate 30° angle to the workpiece with the torch
tip within 1.5 mm (1/16 inch) of the workpiece before firing the
torch.
2. Fire the torch while still at an angle to the workpiece. Slowly
rotate the torch to a perpendicular (90°) position.
3. Hold the torch in place while continuing to press the trigger.
When sparks exit below the workpiece, the arc has pierced the
material.
4. When the pierce is complete, drag the nozzle lightly along the
workpiece to proceed with the cut.