Setting the five-position voltage divider, Setting the five-position voltage divider -6, Powermax – Hypertherm Powermax105 Service Manual User Manual

Page 132

Text mode
Original mode

Mechanized cutting

7-6

powermax

105

Service Manual

Setting the five-position voltage divider

To change the factory preset voltage divider from 50:1 to a different setting:
1. Turn OFF the power supply and disconnect the power cord.
2. Remove the power supply cover.
3. Locate the voltage divider DIP switches on the left side of the power supply.

Note: The figure below shows the default setting (50:1) with the number 4 switch up.

4. Set the DIP switches to one of the following settings and replace the power supply cover.

20:1

21.1:1

30:1

40:1

50:1

If the Hypertherm five-position voltage divider does not supply the required voltage for your application, contact your

system integrator for assistance.

This manual is related to the following products:

Powermax105 Operator Manual