Choose the hand torch consumables, Drag-cutting 105 a consumables, Drag-cutting 45 a, 65 a, 85 a consumables – Hypertherm Powermax105 Service Manual User Manual
Page 60: Choose the hand torch consumables -4, Drag-cutting 105 a consumables -4, Drag-cutting 45 a, 65 a, 85 a consumables -4, Powermax
Hand TorcH SeTup
4-4
powermax
105
Service Manual
Choose the hand torch consumables
Hypertherm includes a box of consumables with your system. Both styles of hand torches shown on the previous page
use the same consumables.
Hand torches use shielded consumables. Therefore, you can drag the torch tip along the metal.
Consumables for hand cutting are shown on the next page. Notice that the retaining cap and electrode are the same for
cutting, gouging, and FineCut
®
applications. Only the shield, nozzle, and swirl ring are different.
For the best cut quality on thin materials (approximately 4mm/10GA or less), you may prefer to use FineCut
consumables, or use a 45 A nozzle and reduce the amperage to that setting.
Drag-cutting 105 A consumables
Drag-cutting 45 A, 65 A, 85 A consumables
10
5A
220992
Shield
220854
Retaining cap
220990
Nozzle
220994
Swirl ring
220842
Electrode
65
A
45
A
85
A
220818
Shield
220854
Retaining cap
220941
Nozzle
220819
Nozzle
220816
Nozzle
220994
Swirl ring
220842
Electrode