Hypertherm Powermax105 Service Manual - Manual (Page 213)

Power SuPPly ComPonent rePlaCement
powermax
105 Service Manual 9-15
 Step task Page
 1. Disconnect the power and gas supply 9-16
 2. Remove the power supply cover 9-21
 3. Remove the component barrier 9-21
 4. Remove the end panel bracket 9-22
 5. Replace the front end panel 9-80
 6. Install the end panel bracket 9-90
 7. Install the component barrier 9-91
 8. Install the power supply cover 9-92
Replacing the front end panel
Kit # 228866
 Step task Page
 1. Disconnect the power and gas supply 9-16
 2. Remove the power supply cover 9-21
 3. Remove the component barrier 9-21
 4. Remove the end panel bracket 9-22
 5. Remove the fan shroud 9-55
 6. Disconnect the gas tube 9-32
 7. Remove the power cord 9-33
 8. Remove the strain relief connector 9-35
 9. Replace the rear end panel 9-84
 10. Install the strain relief connector 9-87
 11. Install the power cord 9-88
 12. Connect the gas tube 9-32
 13. Install the fan shroud 9-55
 14. Install the end panel bracket 9-90
 15. Install the component barrier 9-91
 16. Install the power supply cover 9-92
Replacing the rear end panel
Kit # 228867, 228868, 228869
Installing the machine interface cable for raw arc voltage
Kit # 228711
Note: to access divided raw arc voltage, refer to Field Service bulletin 807060.