Remove the start switch, Replace the start switch, Powermax – Hypertherm Powermax105 Service Manual User Manual

Page 300

Torch componenT replacemenT

10-10

powermax

105 Service Manual

Right handle

Strain relief

Torch lead

Right handle

Remove the start switch

1. Pry the start switch up using a flat blade screwdriver.
2. Disconnect the start switch by pressing the tab on the connector and pulling the start switch away from the

connector.

3. Lift the start switch off the two mounting posts in the right handle.

Replace the start switch

1. Pry the start switch up using a flat blade screwdriver.
2. Lift the start switch off the two mounting posts in the right handle.
3. Plug the start switch connector into the new start switch.
4. Press the start switch onto the two mounting posts in the right handle.

Duramax 75° hand torch

Duramax 15° hand torch

Start switch

connector

Start switch

connector

This manual is related to the following products:

Powermax105 Operator Manual