Hypertherm Powermax105 Service Manual - Manual (Page 267)

Power SuPPly ComPonent rePlaCement
powermax
105 Service Manual 9-69
Replace the work lead receptacle
1. Remove the bolt securing the work cable to the work
lead receptacle.
2. Remove the nut and washer securing the work lead
receptacle to the front end panel.
3. Push the work lead receptacle out through the front
end panel.
4. Push the threaded end of the new work lead
receptacle into the opening in the front end panel,
with the keyway facing up, until fully seated.
5. Place the washer over the work lead receptacle
inside the power supply.
6. Tighten the nut onto the work lead receptacle.
7. Secure the work cable to the work lead receptacle
by tightening the bolt.
Keyway up
Work lead receptacle
Front end panel
Bolt Nut
Washer
Work cable
Work lead
receptacle