Comtech EF Data SMS-7000 - Manual (Page 134)

Remote Control Operation SMS-7000 Modem Protection Switch
A–18 Rev. 3 Draft
Character 'aa': Prime #5 system fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime modem communications failure fault.
Bit 4 = Prime modulator configuration verify error fault.
Bit 3 = Prime demodulator configuration verify error fault.
Bit 2 = No address for prime fault.
Bit 1 = No prime modulator configuration loaded fault.
Bit 0 = No prime demodulator configuration loaded fault.
Character 'ab': Prime #5 system fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime not assigned to backup fault.
Bit 4 = Prime multiplexer communications failure fault.
Bit 3 = No address for prime multiplexer fault.
Bit 2 = Reserved.
Bit 1 = Reserved.
Bit 0 = Reserved.
Character 'ac': Prime #5 system fault status character 3.
Bit 6 = 1 always.
Bit 5 = Reserved.
Bit 4 = Reserved.
Bit 3 through Bit 0 = Binary representation (0 through 10)
of the number of Prime #5 system stored faults.
Character 'ad': Prime #6 system fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime modem communications failure fault.
Bit 4 = Prime modulator configuration verify error fault.
Bit 3 = Prime demodulator configuration verify error fault.
Bit 2 = No address for prime fault.
Bit 1 = No prime modulator configuration loaded fault.
Bit 0 = No prime demodulator configuration loaded fault.
Character 'ae': Prime #6 system fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime not assigned to backup fault.
Bit 4 = Prime multiplexer communications failure fault.
Bit 3 = No address for prime multiplexer fault.
Bit 2 = Reserved.
Bit 1 = Reserved.
Bit 0 = Reserved.
Character 'af': Prime #6 system fault status character 3.
Bit 6 = 1 always.
Bit 5 = Reserved.
Bit 4 = Reserved.
Bit 3 through Bit 0 = Binary representation (0 through 10)
of the number of Prime #6 system stored faults.
Character 'ag': Prime #7 system fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime modem communications failure fault.
Bit 4 = Prime modulator configuration verify error fault.
Bit 3 = Prime demodulator configuration verify error fault.
Bit 2 = No address for prime fault.
Bit 1 = No prime modulator configuration loaded fault.
Bit 0 = No prime demodulator configuration loaded fault.
Character 'ah': Prime #7 system fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime not assigned to backup fault.
Bit 4 = Prime multiplexer communications failure fault.
Bit 3 = No address for prime multiplexer fault.
Bit 2 = Reserved.
Bit 1 = Reserved.