beautypg.com

Status commands/responses, A.4 status commands/responses – Comtech EF Data SMS-7000 User Manual

Page 127

background image

SMS-7000 Modem Protection Switch

Remote Control Operation

Rev. 3 Draft

A–11

A.4 Status

Commands/Responses

Backup
Modulator
Config.
Status

Command:
Response:

>add/MCS_Bn'cr'
MA_xxx'cr'
ADD_mmm'cr'
SM_xxx'cr'
PMA_mmmmmmmm'cr'
MU_xxx'cr'
MUA_mmm'cr''lf']

(See Note)

Where: n = 1 or 2 (backup modem number).

Modulator Active (YES/NO)
Modem Address
Switching Mode (IND/DEP)
Prime Modem Assignments
Multiplexer Unit Attached (YES/NO)
Multiplexer Unit Address

The backup modulator configuration status command
causes a block of data to be returned by the SMS-7000. The
block of data reflects the stored configuration of the backup
modem selected.

Note: Status only returned if multiplexer unit attached.

Backup
Demodulato
r Config.
Status

Command:
Response:

>add/DCS_Bn'cr'
DA_xxx'cr'
ADD_mmm'cr'
SM_xxx'cr'
PMA_mmmmmmmm'cr'
MU_xxx'cr'
MUA_mmm'cr''lf']

(See Note)

Where: n = 1 or 2 (backup modem number).

Demodulator Active (YES/NO)
Modem Address
Switching Mode (IND/DEP)
Prime Modem Assignments
Multiplexer Unit Attached (YES/NO)
Multiplexer Unit Address

The backup demodulator configuration status command
causes a block of data to be returned by the SMS-7000. The
block of data reflects the stored configuration of the backup
modem selected.

Note: Status only returned if multiplexer unit is attached.

Prime
Modulator
Config.
Status

Command:
Response:

>add/MCS_n'cr'
MA_yyy'cr'
MP_y'cr'
MD_yyy.y'cr'
ADD_mmm'cr'
MU_xxx'cr'
MUA_mmm'cr'

(See Note)

DID_xxxxx'cr'
ECLK_xxxxx'cr'
IDI_xxxx'cr''lf']

Where: n = 1 to 8 (prime modem number).

Modulator Active (YES/NO)
Modulator/Modem Priority
Modulator/Modem Delay
Modem Address
Multiplexer Unit Attached (YES/NO)
Multiplexer Unit Address
Drop & Insert Data (BAL/UNBAL)
External Clock (BAL/UNBAL)
Insert Data Input (LOOP/NORM)

The prime modulator configuration status command causes
a block of data to be returned by the SMS-7000. The block
of data reflects the stored configuration of the prime modem
selected.

Note: Status only returned if multiplexer unit is attached.