Comtech EF Data SMS-7000 User Manual

Page 133

SMS-7000 Modem Protection Switch

Remote Control Operation

Rev. 3 Draft

A–17

Bit 0 = No prime demodulator configuration loaded fault.

Character 's': Prime #2 system fault status character 2.

Bit 6 = 1 always.
Bit 5 = Prime not assigned to backup fault.
Bit 4 = Prime multiplexer communications failure fault.
Bit 3 = No address for prime multiplexer fault.
Bit 2 = Reserved.
Bit 1 = Reserved.
Bit 0 = Reserved.

Character 't': Prime #2 system fault status character 3.

Bit 6 = 1 always.
Bit 5 = Reserved.
Bit 4 = Reserved.
Bit 3 through Bit 0 = Binary representation (0 through 10)
of the number of Prime #2 system stored faults.

Character 'u': Prime #3 system fault status character 1.

Bit 6 = 1 always.
Bit 5 = Prime modem communications failure fault.
Bit 4 = Prime modulator configuration verify error fault.
Bit 3 = Prime demodulator configuration verify error fault.
Bit 2 = No address for prime fault.
Bit 1 = No prime modulator configuration loaded fault.
Bit 0 = No prime demodulator configuration loaded fault.

Character 'v': Prime #3 system fault status character 2.

Character 'w': Prime #3 system fault status character 3.

Bit 6 = 1 always.
Bit 5 = Reserved.
Bit 4 = Reserved.
Bit 3 through Bit 0 = Binary representation (0 through 10)
of the number of Prime #3 system stored faults.

Character 'x': Prime #4 system fault status character 1.

Character 'y': Prime #4 system fault status character 2.

Character 'z': Prime #4 system fault status character 3.

Bit 6 = 1 always.
Bit 5 = Reserved.
Bit 4 = Reserved.
Bit 3 through Bit 0 = Binary representation (0 through 10)
of the number of Prime #4 system stored faults.