Breakout, System, A.3.4 breakout – Comtech EF Data SMS-7000 User Manual
Page 125: A.3.5 system
SMS-7000 Modem Protection Switch
Remote Control Operation
Rev. 3 Draft
A–9
Verify
Prime
Modem X
Command:
Response:
Where: x = 1 or 8 (prime modem number).
Note: Status can be polled after operation by using the MNF_
command.
Verify All
Modems
Command:
Response:
Notes:
1. This command will verify all active backup and prime
modem configurations match those stored in the switch.
2. Status can be polled after operation by using the MNF_
command.
A.3.4 Breakout
Drop and
Insert
G.703 Data
Command:
Response:
Status:
Response:
Where:
n = 1 to 8 (prime channel number).
xxxxx = BAL (Balanced) or UNBAL (Unbalanced).
External
Clock
Command:
Response:
Status:
Response:
Where:
n = 1 to 8 (prime channel number).
xxxxx = BAL (Balanced) or UNBAL (Unbalanced).
Insert Data
Input
Command:
Response:
Status:
Response:
Where:
n = 1 to 8 (prime channel number).
xxxx = LOOP or NORM (for NORMAL).
A.3.5 System
Time of Day
Command:
Response:
Status:
Response:
Where:
hh = 1 to 12 (hours).
mm = 00 to 59 (minutes).
xx = AM or PM.
Date
Command:
Response:
Status:
Response:
Where:
mm = 1 to 12 (month).
dd = 1 to 31 (day).
yy = 00 to 99 (year).
Modem
Control
Baud Rate
Command:
Response:
Status:
Response:
Where: mmmmm = 9600 or 19200.
Note: Enter command in Manual mode only.
Remote
Operation
Command:
Response:
Notes:
1. Configures the SMS-7000 for remote operation.
2. The SMS-7000 will respond to any status request at
any time. However, the SMS-7000 must be in Remote
mode to change configuration parameters remotely.
Clear
Stored
Faults
Command:
Response:
This command is used to clear all stored faults logged by the
SMS-7000.