Comtech EF Data SMS-7000 - Manual (Page 132)

Remote Control Operation SMS-7000 Modem Protection Switch
A–16 Rev. 3 Draft
Bit 1 = Reserved.
Bit 0 = Reserved.
Character 'k': Backup #1 system fault status character 3.
Bit 6 = 1 always.
Bit 5 = Reserved.
Bit 4 = Reserved.
Bit 3 through Bit 0 = Binary representation (0 through 10)
of the number of Backup #1 system stored faults.
Character 'l': Backup #2 system fault status character 1.
Bit 6 = 1 always.
Bit 5 = Backup modem communications failure fault.
Bit 4 = Backup modulator configuration verify error fault.
Bit 3 = Backup demodulator configuration verify error
fault.
Bit 2 = No address for backup fault.
Bit 1 = No backup modulator configuration loaded fault.
Bit 0 = No backup demodulator configuration loaded
fault.
Character 'm': Backup #2 system fault status character 2.
Bit 6 = 1 always.
Bit 5 = No primes assigned to backup fault.
Bit 4 = Backup multiplexer communications failure fault.
Bit 3 = No address for backup multiplexer fault.
Bit 2 = Reserved.
Bit 1 = Reserved.
Bit 0 = Reserved.
Character 'n': Backup #2 system fault status character 3.
Bit 6 = 1 always.
Bit 5 = Reserved.
Bit 4 = Reserved.
Bit 3 through Bit 0 = Binary representation (0 through 10)
of the number of Backup #2 system stored faults.
Character 'o': Prime #1 system fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime modem communications failure fault.
Bit 4 = Prime modulator configuration verify error fault.
Bit 3 = Prime demodulator configuration verify error fault.
Bit 2 = No address for prime fault.
Bit 1 = No prime modulator configuration loaded fault.
Bit 0 = No prime demodulator configuration loaded fault.
Character 'p': Prime #1 system fault status character 2.
Bit 6 = 1 always.
Bit 5 = Prime not assigned to backup fault.
Bit 4 = Prime multiplexer communications failure fault.
Bit 3 = No address for prime multiplexer fault.
Bit 2 = Reserved.
Bit 1 = Reserved.
Bit 0 = Reserved.
Character 'q': Prime #1 system fault status character 3.
Bit 6 = 1 always.
Bit 5 = Reserved.
Bit 4 = Reserved.
Bit 3 through Bit 0 = Binary representation (0 through 10)
of the number of Prime #1 system stored faults.
Character 'r': Prime #2 system fault status character 1.
Bit 6 = 1 always.
Bit 5 = Prime modem communications failure fault.
Bit 4 = Prime modulator configuration verify error fault.
Bit 3 = Prime demodulator configuration verify error fault.
Bit 2 = No address for prime fault.
Bit 1 = No prime modulator configuration loaded fault.