Avery Dennison SNAP 611 - Manual (Page 81)

Users Manual – 610 / 611/ 612 Printers 9. Troubleshooting • 73
614 Portion of field off tag.
615 Bar code width is greater than 16 inches, or keywords of PDF417 bar code exceed
928.
616 A bad dot falls on a bar code that cannot be shifted. Call Service or replace the
printhead.
618 Magnification must be 1 to 7 or 4 to 255 for the scalable font.
620 Font and printhead density mismatch. Check the font or verify the correct printhead
(203 dpi or 300 dpi) is installed.
621 An error occurred opening the TrueType font file. Select a different font to download.
If the error message persists, call Technical Support.
622 Not enough memory to create the downloaded TrueType characters in the scalable
(vector) fonts buffer. Reconfigure the printer's memory and increase the scalable fonts
buffer. If the error message persists, call Technical Support.
Machine Faults
Errors 700 to 765 happen when there is a problem with the printer.
Error Description / Action
700
An error is pending and the printer cannot continue with the batch.
701 Printer received a command that it cannot execute while it is running.
702 Check your printer’s SETUP settings.
703 The printer sensed a calibration of different-sized black marks.
704 Printer didn’t detect a sense mark within the maximum feed length or out of supplies.
Check or load supplies.
705 Invalid batch received.
750 Printhead is overheated. Turn off the printer and let it cool.
751 Printer didn’t detect a sense mark when expected.
752 Printer detected a sense mark in the wrong place.
753 Printer detected a sense mark that is too long.
754 Out of ribbon or ribbon jam. Check or load ribbon. Remove any slack in the ribbon by
turning the take-up reel clockwise. Load a new ribbon.
755 Printhead is open. Close the printhead.
756 Out of supplies. Load supplies.
757 Reload supplies (supply length mismatch).