Avery Dennison SNAP 611 - Manual (Page 30)

22 • 3. Setting Supply Options Users Manual – 610 / 611/ 612 Printers
2. Press Enter / Pause to set the supply type option. You will see the current setting, for
example:
SUPPLY TYPE
Å Black Mark Æ
3. Press Í or Î to see the other options. After you display the option you want, press
Enter / Pause. Press Escape / Clear twice to exit to the Main Menu.
Note: Select “Continuous” only for the 612 printer. The 612 printer does not support
indexed supplies.
Ribbon
You have to tell the printer if your supplies require a ribbon.
To change the setting, from the Main Menu, select Setup, then Supply. Then, follow these
steps.
1. Press Í or Îuntil you see
SUPPLY
Å
Ribbon Æ
2. Press Enter / Pause to set the ribbon option. You will see the current setting, for
example:
SUPPLY
Å
Yes Æ
3. Press Í or Î to see the other options. After you display the option you want, press
Enter / Pause. Press Escape / Clear twice to exit to the Main Menu.
If you set the Ribbon option to Yes, install a ribbon before printing.
If you want to use a high energy ribbon, select high energy for the ribbon
every time the printer is turned on.
Speed
You can change the print speed for bar codes or graphics. If you select "default" for speed,
formats with serial bar codes automatically print at 2.5IPS and formats with parallel bar codes
print at 6.0 ips. 10 ips printing is only available using thermal direct labels in continuous
mode.
To change the setting, from the Main Menu, select Setup, then Supply. Then, follow these
steps.
1. Press Í or Î until you see
SUPPLY
Å
Speed Æ