Avery Dennison SNAP 611 - Manual (Page 69)

Users Manual – 610 / 611/ 612 Printers 8. Diagnostics • 61
8. Diagnostics
This chapter explains how to perform simple diagnostic functions such as checking the
software version, the supply quality, printing test labels, and using password protection.
Factory Set Password
You need a password to access diagnostic functions. Press Feed / Cut three times and then
press Enter / Pause.
Checking the Software Version
1. From the Diagnostics Menu, press Í or Î until you see
DIAGNOSTICS
Version Æ
2. Press Enter / Pause. You will see
Model M9855
V 1.8
Line one lists the printer model number (M9855) and line two gives the version of
software in the printer.
Printing a Test Label
NOTE: DO NOT PRINT A TEST LABEL ON A 612 PRINTER.
1. From the Diagnostics Menu, press Í or Î until you see
DIAGNOSTICS
Å
User Diag Æ
2. Press Enter / Pause and Î until you see
USER DIAG
Å Test Label
3. Press Enter / Pause. The following test labels print.
The first label shows the printer's configuration by packet (A-G). The second label shows the
model number, software version, stock count, voltage, print contrast, printhead resistance,
number of bad dots, and installed options. The test label also shows an inch count for the
high energy ribbon. This information will help Technical Support diagnose the problem. Refer
to the optional Packet Reference Manual for more information about the test label.