Avery Dennison SNAP 611 - Manual (Page 27)

Users Manual - 610 / 611 / 612 Printers 2. Loading Supplies • 19
7. Slide the ribbon onto the back reel as far as it will go with the writing on the end of the
core facing out. The ribbon roll only fits on the reel one way. Carefully unwind a few
inches of ribbon from the bottom of the roll.
8. Carefully feed the ribbon under both ribbon rollers and printhead as shown.
9. Tape the ribbon to the take-up core. Do not tape the ribbon to the take-up reel.
10. Align the ribbon with the printhead and supply.
CAUTION
Make sure the ribbon is straight and centered throughout the path.
11. Rotate the take-up core until the leader is past the printhead.
12. Remove any slack in the ribbon by turning the take-up reel clockwise.
13. Hold the printhead assembly by the printhead tab while pressing down on the printhead
release.
Take-up Reel
Take-up Core
Ribbon Roller