Avery Dennison SNAP 611 - Manual (Page 57)

Users Manual – 610 / 611/ 612 Printers 6. Printing • 49
Using the Knife
The installed knife is two and a half (2-1/2) inches away from the printhead. Pressing and
holding Feed / Cut for two seconds marks the tag under the printhead to be cut when it
reaches the knife. Depending on the length of your supply, you may lose up to two tags after
the last batch.
The knife operates when the printer is running. If the printer is paused,
the knife stops cutting.
Adjusting the Drop Tray
Depending on the model purchased, your printer may have a drop tray stacker. Adjust the
drop tray by removing the plastic pins and re-inserting them according to the diagram below.
Select the setting based on the length of your label.