Avery Dennison SNAP 611 - Manual (Page 48)

40 • 5. Setting Defaults Users Manual – 610 / 611/ 612 Printers
Using Flash Memory
The flash memory options are listed in the table below.
Option Choices Default
Format Flash No / Yes No
Unused Flash NA NA
Pack Flash No / Yes No
Formatting Flash Memory
Before storing packets in flash memory, downloading a script, or if the printer's firmware is
updated, you must format the flash memory. Formatting flash memory is only required
once during initial printer setup.
When you format flash memory, the script and any downloaded
TrueType  fonts saved in the printer's flash memory are deleted and
must be resent to the printer.
To format flash memory, from the Main Menu, select Setup. Then, follow these steps.
1. Press Í or Î until you see
SETUP
Å
Flash Memory Æ
2. Press Enter/Pause.
FLASH MEMORY
Format Flash Æ
3. Press Enter/Pause.
Are you sure?
No Æ
4. Press Î to display "Yes" and press Enter/Pause.
CREATING FLASH
FILE SYSTEM 1
The printer's flash memory is cleared and reformatted. This process may take several
minutes. The printer reboots automatically after formatting flash memory. You need to
resend any fonts you want to use to flash memory again. You return to "Print Mode Ready."