Avery Dennison SNAP 611 - Manual (Page 61)

Users Manual – 610 / 611/ 612 Printers 7. Care and Maintenance • 53
7. Care and Maintenance
This chapter tells you how to
♦ Clear supply jams
♦ Clear knife jams
♦ Clean the printhead and platen roller
♦ Replace a printhead
♦ Lubricate the knife
CAUTION
Do not use sharp objects to clean the printhead. This may damage the
printer and void your warranty.
Clearing Supply Jams
When you are printing and a jam occurs, the Fault light on the printer's front panel blinks. To
clear the jam:
1. Turn off the printer.
2. Open the cover and printhead assembly.
3. If necessary, remove the supply roll and ribbon.
4. Remove the jammed supply and reload the supply roll.
5. Close the printhead assembly and turn on the printer.
6. Press Feed / Cut to position the supply under the printhead.
Clearing a Knife Jam
If tags are jammed in the knife, the printer displays 760 on the LED. To clear a knife jam, you
might have to disconnect the stacker from the knife.
1. Turn off the printer.
2. You can see the tag path in the knife by looking through the slot on the top of the knife.
Clear the tag path by using a tool, such as a screwdriver or needle-nose pliers, to pull the
jammed tags out of the knife.
CAUTION
DO NOT PLACE YOUR FINGERS NEAR THE KNIFE’S BLADE. DO
NOT USE EXCESSIVE FORCE TO REMOVE TAGS BECAUSE
DAMAGE TO THE KNIFE MAY OCCUR.
3. Turn on the printer. Send a test batch of tags to the printer.