Avery Dennison SNAP 611 - Manual (Page 34)

26 • 3. Setting Supply Options Users Manual – 610 / 611/ 612 Printers
♦ If the data is too close to the left side, increase the number.
♦ If the data is too close to the right side, decrease the number.
Changing this setting only affects new formats sent to the printer.
To change the setting, from the Main Menu, select Setup, then Supply, then Positioning.
Then, follow these steps.
1. Press Í or Î until you see
Positioning
Å
Margin Pos Æ
2. Press Enter / Pause. You will see the current setting, for example:
Enter margin pos
[-99/99]: +0
3. Press Í or Î to change the margin position. Pressing Í decreases the value
(moves the image toward the left side of the supply); Î increases it (moves the image
toward the right side of the supply).
4. Press Enter / Pause when the number you need appears. Press Escape / Clear twice to
exit to the Main Menu.
Cut Position
This function adjusts where the tag is cut. The printer adjusts the cut position according to the
black marks on the supply. You may need to adjust for aperture supplies. Increase to move
the cut up; decrease to move the cut down.
To change the setting, from the Main Menu, select Setup, then Supply, then Positioning.
Then, follow these steps.
1. Press Í or Î until you see
Positioning
Å
Cut Pos Æ
2. Press Enter / Pause. You will see the current setting, for example:
Enter knife adj
[-300/300]: +0
3. Press Í or Î to change the cut position. Pressing Í decreases the value (moves
the cut down); Î increases it (moves the cut up).
4. Press Enter / Pause when the number you need appears. Press Escape / Clear to exit
to the Setup Menu.