Avery Dennison SNAP 611 - Manual (Page 10)

2 • 1. Getting Started Users Manual - 610 / 611 / 612 Printers
Audience
The User’s Manual is for the person who prints and applies labels.
Unpacking the Printer
After you unpack the printer, you should have: a 610 / 611 / 612 printer, power cord,
communication cable and a ribbon take-up core (may already be on take-up reel).
Keep the box and packaging material in case the printer ever needs repair.
Power cords are not supplied with 230-volt printers. You need to purchase a power cord
separately. The power cord requires IEC 320 STD C13 end finish for the printer interface and
it must meet requirements for 1.6 Amps at 115VAC and 1 Amp at
230VAC.
Shipping the Printer
If you need to ship the printer to a different location:
1. Remove the ribbon roll, if one is loaded.
2. Remove the supply roll, if one is loaded.
3. Close the printhead by pressing down on the thumb well until
you hear it click into place.
4. Place the printer in the original box and secure with packaging
material. Make sure the printer is adequately packed to
avoid damage during shipment.
Connecting the Power Cable
To connect the power cable:
1. Plug the power cable into the socket. Plug the other
end of the cable into a grounded electrical outlet.
2. Turn on the printer. Press ( I ) to turn on and ( O ) to
turn off the printer.
Power
Cable goes
here