Avery Dennison SNAP 611 - Manual (Page 33)

Users Manual – 610 / 611/ 612 Printers 3. Setting Supply Options • 25
Supply Position
This function adjusts the machine to print at the vertical 0,0 point on the supply.
The supply position adjustment should only be made on initial printer
setup. For format adjustments, change the print position.
You may need to adjust the supply in or out to allow
♦ tags and labels to be removed.
♦ die cut labels to be removed easily.
The adjustments are in dots (0.0049 inch).
♦ Increase the number to feed more supply out of the chute.
♦ Decrease the number to feed less supply out of the chute.
This option takes effect on the next label or tag printed. Changing supply position may also
affect print position.
To change the setting, from the Main Menu, select Setup, then Supply, then Positioning.
Then, follow these steps.
1. Press Í or Î until you see
Positioning
Å
Supply Pos Æ
2. Press Enter / Pause. You will see the current setting, for example:
Enter supply pos
[-300/300]: +0
3. Press Í or Î to change the supply position. Pressing Í decreases the value (feeds
less supply); Î increases it (feeds more supply).
4. Press Enter / Pause when the number you need appears. Press Escape / Clear twice to
exit to the Main Menu.
Margin Position
This function adjusts where the format prints horizontally on the supply. The adjustments are
in dots (0.0033 inch), which is the smallest measurement the printer recognizes.
The width of the print area depends on your supply size. Maximum width is four inches.
When you move the image to the right or left on the supply, avoid moving the image too close
to either edge, because it may not print.
Print too far to the left. Print too far to the right.