Avery Dennison SNAP 611 - Manual (Page 41)

Users Manual – 610 / 611/ 612 Printers 4. Communication Values • 33
Flow Control
To change the setting, from the Main Menu select Setup, Port Settings, then Serial Comm.
Then, follow these steps:
1. Press Í or Î until you see
SERIAL COMM
Å Flow Control Æ
2. Press Enter / Pause. You will see the current setting, for example:
FLOW CONTROL
Å DTR Æ
3. Press Í or Î to display the flow control you need, then press Enter / Pause. Press
Escape / Clear three times to exit to the Main Menu.
XON is 17; XOFF is 19. Set flow control to DTR for PC computers (unless you have
XON / XOFF software).
Reset to Default Values
To change the setting, from the Main Menu select Setup, Port Settings, then Serial Comm.
Then, follow these steps:
1. Press Î until you see
SERIAL COMM
Å Reset
2. Press Enter / Pause. You will see
Are you sure?
No Æ
3. Press Í or Î to make your selection, then press Enter / Pause. Press Escape /
Clear three times to exit to the Main Menu.
The following defaults are restored: 9600 baud, No parity, 8 bit word length, and 1
stop bit.
Parallel Communications
The parallel communications menu allows you to set the active parallel port to either internal
or external. The internal port is used for printer options installed inside the printer, such as the
Ethernet communication port. Use the external selection when connecting a printer cable or
external device directly to the parallel port.
The mode selection allows the user to select either compatible or IEEE-1284 mode when
using the selected parallel port. Usually, the mode should be set to compatible for computer
connection using a parallel cable and to IEEE-1284 when using an Ethernet port option.