Replacing the printhead – Avery Dennison SNAP 611 User Manual
Page 64
56
•
7. Care and Maintenance
Users Manual – 610 / 611/ 612 Printers
Replacing the Printhead
You may have to replace the printhead if it is damaged or worn-out. For example, you may
see 616 (bad dot or dots) or 768 (printhead failure) error codes.
CAUTION
The printhead is sensitive to static electricity, which can damage the
printhead or reduce its life. Ground yourself by touching some metal,
such as the printer's metal base, before touching the printhead. Clean
the printhead to remove any salt or oil left from handling prior to
operation.
To replace the printhead:
1.
Turn off the printer.
2.
Open the cover.
3.
Unlock the printhead by turning the retaining latch.
4.
Press forward and down on the two latches on top of the printhead assembly as shown.
The printhead will drop down.
5.
Lift the printhead assembly using the printhead tab and push back until the printhead
assembly clicks into place.