Avery Dennison SNAP 611 - Manual (Page 12)

4 • 1. Getting Started Users Manual - 610 / 611 / 612 Printers
Default Serial Port Communication Values
If you are communicating with the host through the serial port, make sure the printer's
communication values match those at the host. The factory default values are: 9600-Baud, 8
bit data frame Word Length, 1 Stop Bit, no Parity, and XON / XOFF Flow Control.
To change the printer's communication values, ask your System Administrator or see Chapter
4, "Communication Values," for more information.
Default Printer Settings
These defaults can be changed using Paxar's PCMate software. Print Speed - 4.0 ips (inches
per second), Ribbon - High Energy, Supply Type - Black Mark, Contrast - 225, Backfeed -
Disabled.
Using the Control Panel
The control panel has a two-line LCD display, 2 status lights, and five buttons. The control
panel displays error codes / messages, and allows you to setup-configure the printer.
Printer Status Lights
Power: The printer shows a steady green light when
it is on.
Fault: The printer shows a blinking amber light when
there is a printer error.