Avery Dennison SNAP 611 - Manual (Page 29)

Users Manual – 610 / 611/ 612 Printers 3. Setting Supply Options • 21
3. Setting Supply Options
This chapter explains how to select the supply type, ribbon, speed, feed mode, backfeed, print
position, supply position, margin position, cut position, dispense position, backfeed distance,
separators, and skip index mode.
You may need to set supply options when you change supplies. The options are listed in the
table below.
Option Choices Default
Supply Type Aperture / Die Cut / Black Mark / Continuous Black Mark
Ribbon No / Yes / High Energy High Energy
Speed 2.5 / 4.0 / 6.0 / 8.0 / 10.0 / Default 4.0 IPS
Feed Mode Continuous / On-Demand Continuous
Backfeed Off / On / Extended Off
Print Position -99 to +99 0
Supply Position -300 to +300 0
Margin Position -99 to +99 0
Cut Position -300 to +300 0
Dispense Position 50 to 200 65
Backfeed Distance 10 to 200 65
Separators No / Yes / Long No
Skip Index No/ Yes No
Contrast -699 to 699 225
Verifier, State Disabled / Enabled Disabled
To exit an option without changing the setting, press Escape / Clear.
Supply Type
You can print on aperture, black mark, die cut, or continuous supplies. You have to tell the
printer which supplies you are using.
If you are using edge aperture supplies, use the die cut setting. If you are
using center aperture supplies, use the aperture setting.
To change the setting, from the Main Menu, select Setup, then Supply. Then, follow these
steps.
1. Press Í or Î until you see
SUPPLY
Å
Supply Type Æ