Avery Dennison SNAP 611 - Manual (Page 42)

34 • 4. Communication Values Users Manual – 610 / 611/ 612 Printers
The parallel communication values are listed in the table below.
Option Choices Default
Port External / Internal External
Mode Compatible / IEEE-1284 Compatible (Centronics mode)
Port
To change the setting, from the Main Menu select Setup, Port Settings, then Parallel Comm.
Then, follow these steps.
1. Press Í or Î until you see
PARALLEL COMM
Port Æ
2. Press Enter / Pause.
PORT
External Æ
3. Use Í or Î to select either "External" or "Internal." Press Enter/Pause. The internal
port is used for printer options installed inside the printer, such as the Ethernet
communication port. The external port is used to connect a printer cable or external
device directly to the parallel port.
4. Press Escape / Clear until you see the Main Menu.
Mode
To change the setting, from the Main Menu select Setup, Port Settings, then Parallel Comm.
Then, follow these steps.
1. Press Í or Î until you see
PARALLEL COMM
Å Mode
2. Press Enter/Pause.
MODE
Compatible Æ
3. Use Í or Î to select either "Compatible" or "IEEE1284." Press Enter / Pause. Use
compatible mode for a computer connection to the printer with a parallel cable. Use
IEEE-1284 for bi-directional Ethernet communications.
4. Press Escape / Clear until you see the Main Menu.