Avery Dennison SNAP 611 - Manual (Page 32)

24 • 3. Setting Supply Options Users Manual – 610 / 611/ 612 Printers
Positioning
This menu includes selections to change the print, supply, margin, cut, and dispense position
along with the backfeed distance.
When you see
Enter print pos
[-99/99]: +0
Feed / Cut acts as a toggle switch to change the value by 10 or 1. For example, to make the
print position 23 (from the default of 0), press Feed / Cut, then press Î twice (20), press
Feed / Cut again and press Î three times (23).
Print Position
This function adjusts where data prints vertically on the supply. Adjust the print if it is too
close to the top or bottom of the supply, or overtypes the pre-printed area. One dot is 0.0049
inch.
♦ If the data is too close to the bottom, increase the number.
♦ If the data is too close to the top, decrease the number.
Changing this setting only affects new formats sent to the printer.
To change the setting, from the Main Menu, select Setup, then Supply, then Positioning.
Then, follow these steps.
1. Press Í or Îuntil you see
Positioning
Å
Print Pos Æ
2. Press Enter / Pause. You will see the current setting, for example:
Enter print pos
[-99/99]: +0
3. Press Í or Î to change the print position. Pressing Í decreases the value (moves
the image down); Î increases it (moves the image up).
4. Press Enter / Pause when the number you need appears. Press Escape / Clear twice to
exit to the Main Menu.