Artesyn iVPX7225 Installation and Use (April 2015) - Manual (Page 79)

BIOS
iVPX7225 Installation and Use (6806800S11C) 60
 PCI-to-PCI Bridge (VID 8086, DID 1C10)
 Universal Serial Bus (USB) Controller (VID 8086, DID 1C26)
 PCI-to-ISA Bridge (VID 8086, DID 1C43)
 Mass Storage Controller (VID 8086, DID 1C03)
 System Management Bus (VID 8086, DID 1C22)
 PEX 8617 PCI-to-PCI Bridge (VID 10B5, DID 8617)
 82580 Ethernet Gigabit Controller (VID 8086, DID 1516)
5.6 I/O Device Configuration
The iVPX7225 has two serial ports routed to the backplane. COM0 and COM1 are also
accessible via Rear Transition Module (RTM).
COM0 is located on the RTM front panel. A micro-miniDB9 to DB9 adapter cable may be used
to connect to a standard port.
COM1 is accessible via RTM planar header P701. By default, BIOS ConsoleIO is re-directed to
both COM0 and COM1.
Default configuration of COM0 is 0x3F8/IRQ4. Default configuration of COM1 is 0x2F8/IRQ3.
Each COM port defaults to RS-232 with a date rate of 115200-8-n-1.
5.7 Boot Options
The BIOS can boot to any of the following devices and as specified in the boot ordering:
 USB Devices (onboard or external)
 SATA Hard Disk
 SATA Solid State Device (SSD)
 Network (PXE) Boot
 Internal EFI Shell