Artesyn iVPX7225 Installation and Use (April 2015) - Manual (Page 48)

Hardware Preparation and Installation
iVPX7225 Installation and Use (6806800S11C) 29
2.4.3 Rear Transition Module
The iVPX7225-RTM does not support hot swap, you should remove power to the rear slot or
system before installing the RTM module.
Installing the RTM
1. Turn off all equipment power and then disconnect the power cable from the power
source.
2. Remove the chassis cover as instructed in the equipment user's manual.
3. Remove the filler panel(s) from the appropriate card slot(s) at the rear of the chassis
(if the chassis has a rear card cage).
4. Slide the top and bottom edge of the transition module into the rear guide rails of
the chassis.
5. Ensure that the lever of the injector/ejector is in the outward position.
Product Damage
 Installing or removing the product while power is applied damages the product.
Power off the rack before installing or removing the product.
Product Damage
 Only use injector handles for board insertion to avoid damage to the front panel and/or
PCB. Deformation of the front panel can cause an electrical short or other board
malfunction.
Board Malfunction
 Switches marked as “reserved” might carry production-related functions and can cause
the board to malfunction if their setting is changed.
Do not change settings of switches marked as “reserved”. The setting of switches which
are not marked as “reserved” has to be checked and changed before board installation.