Artesyn iVPX7225 Installation and Use (April 2015) - Manual (Page 49)

Hardware Preparation and Installation
iVPX7225 Installation and Use (6806800S11C) 30
6. Slide the transition module into the chassis until resistance is felt.
7. Move the injector/ejector lever in an inward direction.
8. Verify that the transition module is properly seated and secure it to the chassis
using the two screws located at the edges of the face plate.
9. Connect the appropriate cables to the transition module.
2.5 Installing and Removing the Board
This section describes the recommended procedure for installing the board in a chassis. Make
sure to read all warnings and instructions before installing the board.
The iVPX7225 does not support hot swap. Remove power to the slot or system and make sure
that the serial ports and switches are properly configured.
Product Damage
 Installing or removing the product while power is applied damages the product.
 Power off the rack before installing or removing the product.
Product Damage
 Only use injector handles for board insertion to avoid damage to the front panel and/or
PCB. Deformation of the front panel can cause an electrical short or other board
malfunction.
Board Malfunction
 Switches marked as “reserved” might carry production-related functions and can cause
the board to malfunction if their setting is changed.
Do not change settings of switches marked as “reserved”. The setting of switches which
are not marked as “reserved” has to be checked and changed before board installation.