Artesyn iVPX7225 Installation and Use (April 2015) - Manual (Page 60)

Controls, LEDs and Connectors
iVPX7225 Installation and Use (6806800S11C) 41
The following table contains detailed description of default behavior / user control options for
these FP LEDs.
The following connectors are available in the front panel:
 Air cooled
– XMC Front I/O
– Reset switch
– Status LEDs
 Conduction cooled
– Reset switch
– Status LEDs
Table 3-3 Face Plate LEDs
LED# Color Description
1 Red/Amber IPMC controlled LED. The LED state is controllable via the
VITA46.11 LED commands. By default, IPMC locally turns on the
LED1 when payload becomes activated or deactivated. An IPMI
OEM command is provided to override this behavior so that IPMC
disables the local control behavior as described above.*
2 Green IPMC controlled LED. The LED state is controllable via the
VITA46.11 LED commands. By default, IPMC locally turns off the
LED2 when payload becomes activated or deactivated. An IPMI
OEM command is provided to override this behavior so that IPMC
disables the local control behavior as described above.*
3 Blue IPMC controlled LED. The LED state is controllable via the
VITA46.11 LED commands. By default, IPMC locally turns on the
LED3 when payload is not activated, and turns off the LED3 when
payload is activated. IPMC will also set LED3 to be blinking locally
during the de-activation. An IPMI OEM command is provided to
override this behavior so that IPMC disables the local control
behavior as described above.*
*: Refer iVPX7225 Control via IPMI Programmer’s Reference manual for detailed information about OEM
commands.