DynaScan Indoor 360 Degree LED Video Display DS0808 User Manual

Page 84

Active Virtual Encoder

This feature is used to replace the hardware encoder with a software

encoder. This tool is made to be used only by technicians.

All Off / All On

This function allows all of the LED Modules to be turned on/off all at

once.

[*Note] This feature is only available on some models.

LED Scan

This function is used to select how long to turn the individual LED

Module on/off in sequence. The editable fields allow options from 1-10

seconds. Click the “Scan” toggle button to start the operation and click

the “Stop” button to stop, click the “Pause” button to pause the operation

and click it again to continue the operation.

All the LED Moduls will turn on after the “Scan” button is pressed. The

sequence will turn on all of the LED Modules one at a time, and then

turn off all the LED Modules, one at a time. This process will repeat until

the “Stop” button is pressed. The selected time acts as the interval

between turning the LED Modules on and off.

[*Note] Not all models support this function.

LEDM Control

Click on the LED Module number to turn that actual LED module on/off.

* Comment: Green = On, Black = Off, Grey = Not Detected

This manual is related to the following products: