DynaScan Indoor 360 Degree LED Video Display DS0808 User Manual

Page 20

Sharpness

Change sharpness of the image. The image may be blurred by moving the

slider to the left, and sharpened by moving the slider to the right.

Accelerator

Select the video hardware accelerator used to play content. When selecting

‘Default’, AP3 will default to the accelerator setting in the ‘Options’. If an

accelerator is specified, only the current content will adopt the accelerator

setting, and no other content will be affected, nor will the accelerator setting be

changed in ‘Options’.

For more information about accelerators, please see page 30.

Maintain Aspect Ratio

By default, the picture will stretch video content to fit the size of the view

window. As a result of different aspect ratio of original file, the image may be

distorted. To maintain the original aspect ratio, check the "Maintain aspect

ratio" box. Because the aspect ratio of the content may differ from the view

window, black margins around picture may appear.

Resolution

Default will use resolution set in “Capture Setting” of “Options”. Only current

Capture will used specified resolution setting. No other content will be affected,

nor will the default resolution setting be changed in “Options”.

High resolution refers to 640x480;

Low resolution refers to 320x240;

Auto function is disabled.

Device ID

AP3 supports Multiple Capture Cards that enables the user to appoint ID and

input image via the Capture Card corresponding to the ID.

Please refer to Capture Direction in Option for ID setup approach. (Page 100)

[*Note]: Selecting Device ID will turn the settings into default.

Set to Default

The settings will be set as the Capture Setting of Option for

default after the

button pressed with the success

message shown to the right. The settings of Volume,

Balance, Accelerator and Maintain Aspect Ratio will not be

set as default.

This manual is related to the following products: