DynaScan Indoor 360 Degree LED Video Display DS0808 User Manual

Page 121

folder “Content” in Drive D.

Device: It sets the removable drive to be the path for storing the playing

content. The program will first check if the removable drive is

supported and is available for selection. The device will show in gray

and is unable to be selected if the device does not exist. Click Device

to pull down the menu and select the device to store the playing

content. The supported devices are CF/Micro Drive, SD/MMC,

MS/MSPRO and Smart Media.

※

NOTE:

Only one Path and Device can be set.

Connect Setting

Client IP: It sets the IP address of the client. Please connect the internet

cable before executing AP3 Config so that the field will show the

PC’s correct IP address. If executing AP3 Config without

connecting the internet, it shows the default IP address

192.168.1.101.

Client Port: It sets the port used by the client. The default is 8766.

FDT Port: It sets the port used for the FDT service. The default is 8768.

Server IP: It sets the IP address of the server. The defaut is 192.168.1.100.

Server Port: It sets the port used by the server. The default is 8765.

Dynamic IP Setting

This setting is required when the client IP address is dynamic. The input IP,

Port and Name have to be the same as the settings on DynaNet server for

proper login.

Use Dynamic IP: It sets up a dynamic IP. The default is disabled.

This manual is related to the following products: