EXFO ETS-1000G User Manual
Page 179
Remote Control Commands
10 Gigabit Ethernet Analyzer
169
Remote control commands (TELNET). Configuration mode
network dns i.i.i.i
Set the IP address of the network node where
the DNS database resides for port Test.
lan dhcp off / on
Disable/enable the DHCP feature for the LAN
port.
lan ip i.i.i.i
Set the IP address of the LAN port.
lan subnet i.i.i.i
Set the subnet mask for the LAN port.
lan gateway i.i.i.i
Set the gateway's IP address for the LAN port.
Interface parameters. Port Test
ifce vlan count off / 1 / 2 / 3
Set the number of VLAN tags.
ifce vlan [1-3] id int
Set the VLAN identifier value.
ifce vlan [1-3] priority int
Set the traffic priority value.
ifce mpls tx lsr i.i.i.i
Set the IP address of the label-switching
router's interface.
ifce mpls tx rule off / on
Disable/enable the rule for sending packets to
the subnet.
ifce mpls tx subnet i.i.i.i
Set the subnet IP address.
ifce mpls tx mask i.i.i.i
Set the subnet mask.
ifce mpls tx stack count off / 1 / 2 / 3
Set the number of labels to be added to the
packet to be transmitted.
ifce mpls tx stack [1-3] label long
Set the label value.
ifce mpls tx stack [1-3] cos int
Set the Class of Service of a labeled packet.
ifce mpls tx stack [1-3] ttl int
The time-to-live of a labeled packet.
ifce mpls rx count off / 1 / 2 / 3
Set the number of labels in incoming packets.
ifce mpls rx [1-3] label long
Set the label value.
Interface parameters. LAN port
lan mac XX:XX:XX:XX:XX:XX
Set the MAC address of the LAN port.
Command
Action