EXFO ETS-1000G - Manual (Page 164)

Remote Control Commands
154 ETS-1000G
Remote control commands (a console terminal)
show rfc2544 back2back rates src The source of load values for the limit load
analysis.
show rfc2544 back2back rates [1-9] The load values to be used for the limit load
analysis.
show rfc2544 advanced wait The Interval parameter value.
show rfc2544 advanced learn The Learning parameter value.
rfc2544 start Start the tests to be conducted in compliance
with RFC 2544.
rfc2544 stop Stop the tests being conducted in compliance
with RFC 2544.
rfc2544 results Results of the tests conducted in compliance
with RFC 2544.
Complex traffic
show ctraf nstreams The number of data streams.
show ctraf stream The number of the stream to be adjusted.
show ctraf duration The duration of generating the specified
quantity of streams.
show ctraf header src mac The source MAC address.
show ctraf header src ip The source IP address.
show ctraf header src udp The source UDP port number.
show ctraf header dst mac The destination MAC address.
show ctraf header dst ip The destination IP address.
show ctraf header dst udp The destination UDP port number.
show ctraf header vlan count The number of VLAN tags.
show ctraf header vlan [1-3] id The VLAN identifier value.
show ctraf header vlan [1-3] priority The traffic priority value.
Command Information to be output to the console