EXFO ETS-1000G - Manual (Page 113)

10 Gigabit Ethernet Analyzer 103
18 Network Parameters
Interface Select the interface (Test or LAN) to be configured.
DHCP If this feature is enabled, the DHCP server will automati-
cally send the port's IP address, the subnet mask, the gate-
way's IP address and the IP address of a node where the
DNS database resides to the tester.
IP address The IP address of the port (Test or LAN) being configured.
There are two ways to set the IP address:

to input the IP address manually (in this case the DHCP
option should be set to Off);

to obtain the IP address over DHCP via selecting the DHCP
option and pressing (On). The obtained IP address will be
valid, if it is displayed in the IP address menu within 1-2
seconds.
Subnet mask It defines a part of the IP address specified in the previous
menu item that refers to the network address and a part that
refers to the address of a node in the network.
Gateway The gateway's IP address.
DNS The IP address of the network node where the DNS
database resides.