EXFO ETS-1000G - Manual (Page 102)

Traffic Generator
92 ETS-1000G
Static Traffic
If ETS-1000G is connected to the network to conduct, for example,
the Packet jitter test, do the following:
1. Open the Network setup menu, specify the IP address of 10G/1G port
or make sure that the device has received the correct IP address via
DHCP.
2. Open the Delay Variation > Setup menu:

Enable the test traffic generator.

Specify the required threshold value.

Specify measurement duration.
3. Open the Traffic generator menu:

Set the generation parameters.

Set the header parameters according to the information provided
in Main header parameters on page 26 and Additional header
parameters on page 27 section.

If the generator is disabled in the Delay Variation > Setup menu,
enable the test traffic generation feature.
4. Open the Delay Variation > Summary menu and press (Start).
If the local and remote devices are connected to the network, to
conduct the test, do the following:
1. Open the Network Setup menu on the local and remote devices,
specify the IP address of test port or make sure that the device has
received the correct IP address via DHCP.
2. Open the Traffic generator menu on the local device:

Set the generation parameters.

Set the header parameters according to the information provided
in Main header parameters on page 26 and Additional header
parameters on page 27 section.
3. Open the Delay Variation > Setup menu on the remote device: