EXFO ETS-1000G User Manual
Page 173
Remote Control Commands
10 Gigabit Ethernet Analyzer
163
Remote control commands (TELNET). Configuration mode
rfc2544 header tos text
Set the Type of Service of a packet.
rfc2544 throughput duration int
Set the test duration for the throughput
analysis.
rfc2544 throughput enabled no / yes
Disable/enable the throughput analysis.
rfc2544 throughput maxrate
Set the load rate for the throughput analysis.
rfc2544 throughput threshold int
Set the loss threshold value for the throughput
analysis.
rfc2544 throughput resolution 10 / 1 /
0.1 / 0.01 / 0.001 / 0.0001
Set the resolution value for the throughput
analysis.
rfc2544 frames [1-9] enable off / on
Disable/enable the use for an analysis of the
respective frame size.
rfc2544 frames [1-9] size int
Set the frame size.
rfc2544 latency enabled no / yes
Disable/enable the propagation delay analysis.
rfc2544 latency count int
Set the number of test iterations for the
propagation delay analysis.
rfc2544 latency duration int
Set the test duration for the propagation delay
analysis.
rfc2544 latency rates src throughput /
manually
Set the source of load values (throughput,
manually).
rfc2544 latency rates [1-9]
Set the load values for each frame size in %
rfc2544 frameloss enabled no / yes
Disable/enable the frame loss rate analysis.
rfc2544 frameloss duration int
Set the test duration for the frame loss rate
analysis.
rfc2544 frameloss steps int
Set the number of steps for the frame loss rate
analysis.
rfc2544 frameloss rates start
Set the initial load for the frame loss rate
analysis, specified in %.
Command
Action