EXFO ETS-1000G - Manual (Page 178)

Remote Control Commands
168 ETS-1000G
Remote control commands (TELNET). Configuration mode
txgen header vlan [1-3] priority int Set the traffic priority value.
txgen header precedence int Set the frame priority value.
txgen header tos text Set the Type of Service of a packet.
txgen port a / b Select the port on which test traffic is to be
generated.
txgen frame random min int Set the minimum frame size value for the
uniform distribution law.
txgen frame random max int Set the maximum frame size value for the
uniform distribution law.
txgen frame constant int Set the frame sizes to be used for testing.
txgen frame type constant / random Select the frame size variation law.
txgen duration hh.mm.ss Set the measurement duration.
txgen rate Specify the required load.
Loopback
Note: Commands from the Loopback section take effect only after executing the
command “settings apply” or restarting the device using the command
“reboot”.
loopback layer off / 1 / 2 / 3 / 4 Select the layer on which test traffic should be
redirected.
Network parameters
Commands from the Network parameters and Interface parameters sections take effect
only after executing the command “settings apply” or restarting the device using the
command “reboot”.
network dhcp off / on Disable/enable the DHCP feature for port Test.
network ip i.i.i.i Set the IP address of port Test.
network subnet i.i.i.i Set the subnet mask for port Test.
network gateway i.i.i.i Set the gateway's IP address for port Test.
Command Action