EXFO ETS-1000G - Manual (Page 161)

10 Gigabit Ethernet Analyzer 151
C Remote Control Commands
Remote control commands (a console
terminal)
Remote control commands (TELNET)
Command Description
AT An empty command which is used for checking a
connection.
ATR Restart the device.
ATM Display the current measurement results.
ATMN Display the saved measurement results which were
assigned serial number N (N = 1...10)
ATMA Display all saved measurement results.
ATMI Display information about saved measurement
results.
ATI Display information about the device.
ATH Display help information about commands.
ATS Input the key (a number in the decimal format) to
activate options. The key should be specified right
after ats (without a space).
ATC Switch to the mode which allows setting and
starting tests (optionally).
Command Information to be output to the console
RFC 2544
show rfc2544 header src udp The source UDP port number.
show rfc2544 header src mac The source MAC address.
show rfc2544 header src ip The source IP address.
show rfc2544 header dst udp The destination UDP port number.